Operator's Manual
Table Of Contents
- Table of Contents
- 1 — Introduction
- 2 — Warnings, Cautions, and Other Residual Risks
- 3 — System Components
- 4 — Surgery Start Up
- 5 — Surgeon Settings
- 6 — Program Settings
- 7 — System Configuration
- Setting the Maximum IV Pole Height
- Testing the IV Pole
- Event Log
- Wireless Foot Pedal Setup
- VERITAS Remote Control Setup
- System Versions
- System Self Test
- Language Selection
- Surgical Media Center (SMC) (Optional)
- Set System Date and Time
- Set Units of Measure for Vacuum
- Service Interval
- Import/Export Database
- Backup All
- Print to File
- Restore Database
- Restore All
- Delete a Backup Database
- 8 — Symbol Definitions
- 9 — Care and Cleaning
- 10 — Error Messages, Troubleshooting, and Diagnostics
- 11 — Warranty and Maintenance
- 12 — Specifications
- Physical Specifications
- Environmental Specifications
- Electrical Specifications
- Electromagnetic Compatibility
- RF Wireless Technology
- Bluetooth Characteristics
- Phacoemulsification Specifications
- Irrigation and Aspiration Specifications
- Vitrectomy Specifications
- Diathermy Specifications
- Diathermy Power Graphs
- Diathermy Power versus Load Impedance
- Phaco Power Graphs
- Phaco Tip Velocity
- Bottle Height Pressure
- 13 — Accessories and Parts Reordering
- Index
Battery Replacement – VERITAS Remote Control Z370584 Rev. C
10-4
Error Messages, Troubleshooting, and Diagnostics
To replace the battery in the VERITAS Foot Pedal and Advanced Linear Pedal:
1. Use a flat-head screwdriver to remove the battery cover.
NOTE: The screws cannot be separated from the cover.
2. Remove the battery.
NOTE: Dispose of the used battery in the proper manner.
3. Insert a new battery.
NOTE: Ensure to align the positive and negative ends of the battery.
NOTE: Do not install a damaged battery.
4. Replace the cover and tighten the screws.
Battery Replacement – VERITAS Remote Control
To replace the batteries in the VERITAS Remote Control.
1. Turn to the bottom side of the remote.
2. Use a flat screwdriver to remove the two screws.
3. Remove and properly dispose the used batteries.
4. Install two new DURACELL
®
COPPERTOP AA batteries.
5. Close the battery compartment and tighten the screws.
6. Test on a VERITAS Vision System to ensure the remote is fully functional and verify the
battery percentage is renewed.
Charging Options for Wireless Foot Pedals
Figure 10-2 — AC Charger for the Foot Pedal
WARNING!
Do not replace the remote control battery while in use with a patient.
1. AC Charger 2. Foot Pedal Cable 3. Foot Pedal