Operator's Manual
Table Of Contents
- Table of Contents
- 1 — Introduction
- 2 — Warnings, Cautions, and Other Residual Risks
- 3 — System Components
- 4 — Surgery Start Up
- 5 — Surgeon Settings
- 6 — Program Settings
- 7 — System Configuration
- Setting the Maximum IV Pole Height
- Testing the IV Pole
- Event Log
- Wireless Foot Pedal Setup
- VERITAS Remote Control Setup
- System Versions
- System Self Test
- Language Selection
- Surgical Media Center (SMC) (Optional)
- Set System Date and Time
- Set Units of Measure for Vacuum
- Service Interval
- Import/Export Database
- Backup All
- Print to File
- Restore Database
- Restore All
- Delete a Backup Database
- 8 — Symbol Definitions
- 9 — Care and Cleaning
- 10 — Error Messages, Troubleshooting, and Diagnostics
- 11 — Warranty and Maintenance
- 12 — Specifications
- Physical Specifications
- Environmental Specifications
- Electrical Specifications
- Electromagnetic Compatibility
- RF Wireless Technology
- Bluetooth Characteristics
- Phacoemulsification Specifications
- Irrigation and Aspiration Specifications
- Vitrectomy Specifications
- Diathermy Specifications
- Diathermy Power Graphs
- Diathermy Power versus Load Impedance
- Phaco Power Graphs
- Phaco Tip Velocity
- Bottle Height Pressure
- 13 — Accessories and Parts Reordering
- Index
Z370584 Rev. C
3-1
3 — System Components
• “Receipt and Inspection Instructions” on page 3-1
• “VERITAS Vision System Components” on page 3-1
• “Tubing Packs” on page 3-4
• “VERITAS Heel Insert (Optional)” on page 3-15
• “Programmable IV Pole” on page 3-16
• “VERITAS Remote Control” on page 3-16
• “Surgical Media Center (SMC) (Optional)” on page 3-18
Receipt and Inspection Instructions
When you receive your VERITAS
™
Vision System inspect the exterior packaging for any signs
of damage that might have occurred during shipping and record this damage on the shipping
documents. If there are any signs of damage to the exterior packaging, have authorized
personnel carefully unpack the VERITAS Vision System and inspect the system for damage.
If any damage to the package contents has occurred, you must immediately file a claim with
the transporter. The transporters accept claims only from the recipient (you), not from the
shipper (JJSV).
Your JJSV representative will contact you to schedule both the installation and the in-service
training when you receive your new VERITAS Vision System. We suggest that you leave the
VERITAS Vision System in the original packaging. Store the package in a cool, dry
environment until the JJSV installation personnel arrive to assemble, install, and test your
equipment. Extreme heat, cold or moisture can damage any electronic equipment.
VERITAS Vision System Components
Your VERITAS Vision System consists of all or some of the following components:
• VERITAS Vision System console with a touchscreen monitor, a Mayo tray on an adjustable
arm,
detachable power cord, and a programmable IV pole
• Tubing pack (disposable)
• Foot pedal and foot pedal cable (VERITAS Foot Pedal, Single Linear Pedal (SL
P), Advanced
Control Pedal (ACP), or Advanced Linear Pedal (ALP)) (with AC Charger for the ACP,
VERITAS Foot Pedal, and the ALP)
• Wireless VERITAS Remote Control module and VERITAS Vision System Operator Manual
• Surgical Media Center (optional) and VERITAS Heel Insert (optional)