Owners manual

Using the Product
ON/OFF
Button
Zero
Button
ON/OFF Button:
1. Push the ON/OFF button once to turn the unit on.
2. Push the ON/OFF button again to turn the unit off. Note: Moving the ruler
blades with the unit turned off will turn on the unit. To turn the unit completely off,
hold the on/off button in for 4 seconds.
ZERO Button:
1. With the unit turned on, press the zero
button at any point to establish a new zero.
Key Pad
1. Rotate the locking knob clockwise to tighten the ruler blades.
2. Rotate the locking knob counterclockwise to loosen the ruler blades.
Locking Knob
Automatic Shut-Off
This instrument will shut-off automatically if no operation is received within 6 minutes.
1. With the unit turned on, place both ruler blades on
a flat surface (Pic A).
2. With both ruler blades placed flat on a surface, press the zero button.
1. Open the ruler blades to
measure the angle (Pic B).
Calibrating
Measuring Angles
B.
A.
7" Digital Angle Locator and Ruler
Model No. 1888-0700
Localisateur d'angle et règle numérique 7 po
Modèle no 1888-0700
Congratulations on your choice of this Digital Angle Locator and Ruler. We suggest you read this
instruction manual before using the instrument. Save this manual for future use.
Safety Instructions
Please read and understand all of the following instructions prior to using this tool.
Locking Knob
Battery Compartment
LCD
Ruler
7"
Hang Hole
Location of Parts/
Components
Emplacement des pièces
et composants
1.
2.
3.
4.
Battery Installation
1. To open the battery compartment, push the button located below the LCD. The top edge of the battery
compartment will appear above the LCD. (Pic 1)
2. Pull the battery compartment out. (Pic 2)
3. Insert the battery (3V CR2032 Lithium Battery) with the negative side facing up. (Pic 3).
4. Push the battery compartment back into the unit until the battery compartment is flush with the LCD. (Pic 4).
Insertion des piles
1. Pour ouvrir le compartiment de la pile, appuyez sur le bouton situé sous l'écran. Le bord supérieur du
compartiment de la pile apparaîtra au-dessus de l'écran (Figure 1).
2. Retirez le compartiment de la pile en tirant (Figure 2).
3. Insérez la pile (pile au lithium CR2032 3 V) en orientant le pôle négatif vers le haut (Figure 3).
4. Insérez le compartiment de la pile dans l'appareil et appuyez pour que le compartiment ne dépasse plus de
l'écran (Figure 4).
Nous vous félicitons d'avoir choisi ce localisateur d'angle et règle numérique. Nous vous suggérons de lire
attentivement ce mode d'emploi avant d'utiliser cet appareil. Conservez ce mode d'emploi pour pouvoir vous y
référer ultérieurement.
Consignes de sécurité
Veuillez lire et comprendre toutes les instructions suivantes avant d'utiliser cet outil.
1.
2.
3.
4.
Poussez
Poussez
Tirez
Pôle
négatif
Bouton de verrouillage
Compartiment de la pile
LCD
Règle
200mm
Trou de suspension
200mm
7"