User's Manual Part 2

21
minnkotamotors.com
INSTALLATION
FIGURE 35
FIGURE 36
22. Reinstall both side plates using Phillips screwdriver. If
a Co-Pilot was uninstalled, use new ¼-20 x
5
⁄8" Phillips
screws provided. (Figure 35)
23. If a foot pedal is connected to the trolling motor, it
must be disconnected. Once i-Pilot Link has been
installed the foot pedal cannot be used unless i-Pilot Link
is completely uninstalled.
24. Connect i-Pilot Link controller cable to the foot pedal
connector, making sure the connector nut is tight
(Figure 36)
IMPORTANT: DO NOT place dielectric grease or any type
of lubricant in the connector.
25. i-Pilot Link is now installed on the motor. Skip ahead to
the next section to verify the installation.