User Manual

minnkotamotors.com
b. For Riptide SP Motors:
Apply heat shrink insulation
supplied in bag assembly
to the ends of all six loose
AutoPilot connectors as
shown. (Figure 16) Use a
zip tie to bundle connectors
together. Trim the zip tie
and place connector bundle
in the middle of the control
box as shown. (Figure 17)
8. Route i-Pilot controller cable
through grommet hole and
through center of coil cord.
(Figure 18)
FIGURE 18
FIGURE 17 Place insulated AutoPilot wires in the bottom
center of the control box as shown.
17
INSTALLATION
m
innk
ota
m
oto
r
s.co
m