User Manual

minnkotamotors.com
INSTALLATION
12. Secure the i-Pilot controller
cable to the motor coil cord in
all three locations shown using
zip ties provided. (Figure 22)
Trim zip ties using utility knife.
Failure to secure cable will
result in possible damage to
the cabling during operation.
13. Remove the left and right
side plates of trolling motor
by loosening all four side
plate screws using a Phillips
screwdriver. (Figure 23)
FIGURE 23
FIGURE 22
19
Zip Tie
Location 1
Zip Tie
Location 2
Zip Tie
Location 3
m
innk
ota
m
oto
r
s.co
m