User Manual

minnkotamotors.com
PREPARING FOR INSTALLATION
10
m
i
nnkotamotors.co
m
Preparing for Installation
Tools you will need during installation
Terrova and Riptide ST
-Phillips screwdriver
PowerDrive V2
-Phillips screwdriver
-Needle-nose pliers
-Utility knife
-Heat gun or other heat source for installing heat shrink
Riptide SP
-Phillips screwdriver
-Needle-nose pliers
-Utility knife
-Heat gun or other heat source for installing heat shrink
To help with future service work or ordering replacement parts, please refer
to the information box in the Notes section located on page 74 of this manual.
Before installing i-Pilot on your motor, make sure the trolling motor is
properly installed on your boat. Find a clean and dry location for performing
the installation.
Most importantly, disconnect all power to the trolling motor before
installation. Not only will this protect you but also the sensitive electronics
you are about to install.
Read through the entire installation process before performing the installation.
If you need help or need further instruction on installing i-Pilot, please go
online at minnkotamotors.com for a full step-by-step, guided installation video.
You may also call Minn Kota technical service at 1-800-227-6433 to talk to a
customer service representative.