User Manual

minnkotamotors.com
INSTALLATION
i-Pilot Installation on
PowerDrive V2 and
Riptide SP
*Note: Once i-Pilot is installed
in a PowerDrive V2 or Riptide SP
motor, the foot pedal cannot be
used again unless i-Pilot is
fully uninstalled.
1. Remove all power to the
trolling motor.
2. If a CoPilot is installed, it
must be removed as follows:
a. Disconnect motor
connector and foot pedal
connector from CoPilot.
(Figure 7)
b. Remove the CoPilot
receiver from the motor
by removing both
mounting screws. Do not
replace these screws as
the side plates will be
removed in step 13 of this
installation. (Figure 8)
FIGURE 6
FIGURE 7
FIGURE 8
13
mi
nnkotamotors.co
m