User Manual

minnkotamotors.com
5. Remove grommet by pulling
back on coil cord strain relief
and pushing down on
grommet until it pops out.
(Figure 12)
6. Review the cables in the head
of the trolling motor.
a. If a sonar cable is present,
it must be routed around
the outer perimeter of the
control box. The sonar
ground wire should also
be routed as shown.
(Figure 13)
b. The motor power wires
must be routed as shown.
(Figure 13)
INSTALLATION
FIGURE 13
15
Sonar
Ground
Wire
Grommet
Power Wires
AutoPilot Wires
(AutoPilot Motors Only)
Sonar
Cable
mi
nnkotamotors.co
m
FIGURE 12
Sonar Cable (Universal Sonar Motors Only)