User Manual
minnkotamotors.com
INSTALLATION
27
mi
nnkotamotors.co
m
22. Reinstall both side plates using
Phillips screwdriver. If a
Co-Pilot was uninstalled, use
new ΒΌ-20 X 5/8" Phillips screws
provided. (Figure 32)
23. If a foot pedal is connected to
the trolling motor, it must be
disconnected. Once i-Pilot has
been installed the foot pedal
cannot be used unless i-Pilot is
completely uninstalled.
24. Connect i-Pilot controller cable
to the foot pedal connector,
making sure the connector nut is
tight. (Figure 33)
IMPORTANT: DO NOT place
dielectric grease or any type of
lubricant in the connector.
25. i-Pilot is now installed.