User Manual

minnkotamotors.com
GETTING STARTED
KNOWING YOUR
I-PILOT CONTROLLER
Construction
The i-Pilot controller contains a very
sensitive digital compass and is where all
GPS satellite and i-Pilot remote signals are
received. It is very important that the
controller have a clear view of the sky in
all directions and has a clear line of sight to
the remote for optimum performance.
All electronics within the controller
enclosure are completely sealed.
Remote Learning
The i-Pilot remote is prelearned to the controller from the factory. The top of
the controller has a single learn button to allow additional remotes to be added
to the system. To learn additional remotes:
1. Power up the trolling motor.
2. Push and hold the learn button down. A steady audio tone will be heard
while holding this button.
3. While holding the learn button down push any button on the remote
being programmed. Three beeps will be heard when the remote is
successfully learned.
A remote can only be learned to one controller at a time. A controller can have
an unlimited number of remotes learned to it. During the learn process, the
remote must start out in the OFF condition. If necessary, the remote can be
turned off by pressing and holding the Pause button for three seconds.
33
mi
nnkotamotors.co
m
i-Pilot
Speaker
Remote Learn
Button