User's Manual

20
minnkotamotors.com
INSTALLATION
FIGURE 33
Connect
steering wires:
white to white
black to black
19. Connect the black and white wires from the i-Pilot Link
controller cable to the black and white steering motor
wires, making sure black is connected to black and white
is connected to white. (Figure 33)
20. Complete the installation by positioning the heat shrink
over the connections and shrink down, using a heat gun
or other heat source, being careful not to overheat any
wire or parts.
Seal connections with heat shrink.
IMPORTANT: DO NOT OVERHEAT WIRES OR
SURROUNDING PARTS WHEN INSTALLING
HEAT SHRINK!
21. Reinstall center housing over control board by pushing it
down until the side fingers lock into place. The new
i-Pilot Link Controller steering cable should be exiting
the cable exit hole at the center and bottom of the
center housing. (Figure 34)
FIGURE 34