User's Manual

18
minnkot amotor s.com
INSTALLATION
16. Loosen the cable strain relief that is secured to the base
of the motor and install the i-Pilot Link controller steering
cable into the open strain relief slot. (Figure 29)
17. Tighten the cable strain relief as shown. The i-Pilot Link
controller steering cable should slide freely through the
strain relief when installed properly. (Figures 30 and 31)
FIGURE 29
Foot Pedal Cable
Motor Power Cable
i-Pilot Link Controller
Steering Cable
FIGURE 31FIGURE 30
Reinstall strain
relief screw.