User's Manual

moUnTing oPTions

prop in vs. out (provided in outline?) - content needed

Lorem ipsum dolor sit amet, consectetur adipisicing elit, sed do eiusmod tempor incididunt ut labore et dolore magna aliqua. Ut

enim ad minim veniam, quis nostrud exercitation ullamco laboris nisi ut aliquip ex ea commodo consequat. Duis aute irure dolor in

reprehenderit in voluptate velit esse cillum dolore eu fugiat nulla pariatur. Excepteur sint occaecat cupidatat non proident, sunt in

culpa qui oﬃ cia deserunt mollit anim id est laborum.

TooLs And REsoURCEs REQUiREd:

• Drill

• 5/16” Drill Bit

• 7/16” Box End Wrench

• Wire ties for cable routing

• Phillips Screwdriver

• Flat blade screwdriver

insTALLATion

1. Remove the four sideplate screws. Remove sideplates to access the mounting holes.

2. Remove the two 5/16” E-clips retaining the extension damper. Remove the extension damper to expose the front left mounting

hole.

3. Place the motor on the bow of the boat. It is recommended that the motor be mounted as close to the centerline of the boat

as possible. Ensure that the area under the mounting location is clear of anything that would prevent unobstructed drill and

installation of nuts and washers. Make sure that when deployed, the shaft resides a minimum of 1 ½” from the boat rub rail.

This can be done by measuring from X to X. This should be no less than XX.

Figure 1.

Figure 1. Figure 1.

minnkotamotors.com | 7

insTALLATion