User's Manual

4. Once the motor is positioned, mark at minimum four of the six holes that are located farthest apart. Drill through the marked
holes using a 5/16” drill bit
5. Mount the motor to the boat using the provided hardware. Hardware location and orientation should be as shown in the below
fi gure.
6. Reinstall extension damper with shaft facing toward the interior of the boat. Reinstall e-clips
7. Replace the sideplates and sideplate screws.
8. Connect power and other cables
Figure 1.
Figure 1.
Figure 1.
Figure 1.
8 | minnkotamotors.com
©2014 Johnson Outdoors Marine Electronics, Inc.
insTALLATion