User Manual

29
Remark：
Before set for acceleration, check first, when enable select is activated, if it
exceeds limits it will trigger alarm, at the same time if recording is opened it will
start to record. Press direction key to move cursor to X enable, then press
<ENTER> to implement open/close enable, press right key then press <ENTER>,
press digits key to set for the gate limits, press right then press <ENTER> to
implement open/close setting.
3.9.4 Temperature setting
Select refer to Model.
If there is no G-SENSOR it will show：
Fig 27 Model does not support device
3.9.5 On/Off setting