Instructions / Assembly

Jack Chain Wall Drop
www.jonard.com
The installer drills a hole that is large enough to accommodate the desired jack chain size. For a #16 jack chain, this would be
approximately 3/8” in diameter. Jack chain may be acquired from most hardware stores.
The jack chain is then lowered to floor level inside the wall cavity with a pull line or cable attached. A small bend in the cable may be
applied to suspend the jack chain. The installer should always leave an adequate loop in the cable to accommodate the wall height.
The installer will now use the retriever unit to locate the jack chain suspended in the wall. Slowly move the retriever unit left to right at
the outlet location listening for the chain to make contact with the sheet rock. The jack chain will be magnetically pulled against the sheet
rock when the retriever unit passes over it.
This connection verifies the correct wall cavity as well as the chain location.
 When the installer is satisfied with the outlet location, a hole is drilled to retrieve the jack chain. When the hole is complete, the
installer guides the retriever unit to the hole and retrieves the jack chain.
The installer may also position the chain over a small hole and retrieve it with a hook or needle nose pliers.