Installation Sheet

ManualsBrandsJONATHAN Y Lighting ManualsLightingJYL Kurtz Single Light 10" Wide LED Mini Pendant

Model#: JYL3517

Product Dimensions: 10"D X 16.5"H

* Please make sure that you have all parts indicated before you begin assembly of this item

* This item should be assembled on a soft surface to prevent scratching the finish during assembly

* To reduce the risk of fire, electrical shock or injury to persons or property, please follow the guideline below for safe use

and installation

*The external flexible cable or cord of this luminaire cannot be replaced

If the cord is damaged the luminaire shall be destroyed

WARNING

WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN.

WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT

BREAKER BEFORE INSTALLATION.

INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR

OBVIOUS DEFECT, DO NOT INSTALL. ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.

CARE AND MAINTENANCE

To clean the outside of the fixture, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe

the surface of the fixture.

To clean the inside of the fixture, first disconnect power to the fixture by turning off the circuit breaker or by removing the

fuse at the fuse box. Next, use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe the

interior surface of the fixture.

Do not use an

cleaners with chemical

solvents or harsh abrasives. Use onl

a dr

soft cloth to dust or wi

e carefull

NOTICE& IMPORTANT SAFETY INSTRUCTIONS

1/2

PIECE DESCRIPTION PICTURE QUANTIT

PIECE DESCRIPTION PICTURE QUANTITY

mounting

screw

G canopy 1X

mounting

bracket

1X H tube

12“ - 2X

6" - 2X

C machine screw

I socket 1X

D wire connector 3X J bulb 1X

E screwed ball 2X K glass shade 1X

e cor

amage

re s

roye

Part List and Hardware List

F ground screw 1X L set screw 3X

1/2

Summary of content (2 pages)

PAGE 1
WARNING WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN. WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION. INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL. ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
PAGE 2
PREPARATION Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product. Estimated Assembly Time: 20 minutes. 1. Fix the mounting bracket(B) to the outlet box with machine screw(C). 2. Connect the tubes(H) together to get desired length and fix the bottom end to socket(I) , the top end to the canopy.