Installation Guide

PIECE DESCRIPTION PICTURE

QUANTITY

PIECE DESCRIPTION PICTURE QUANTITY

mounting

screw

2X G ScrewedBall 2X

B mountingplate 1X H bulb 3X

C MachineScrew 2X I plasticanchor 4X

D groundscrew 1X J woodscrew 4X

E wireconnector 3X

F body 1X

Model#: JYL7540A

Product Dimensions: 24.5''W X 6"H X 5.125"E

*Pleasemakesurethatyouhaveallpartsindicatedbeforeyoubeginassemblyofthisitem

*Thisitemshouldbeassembledonasoftsurfacetopreventscratchingthefinishduringassembly

*Toreducetheriskoffire,electricalshockorinjurytopersonsorproperty,pleasefollowtheguidelinebelowforsafe

useandinstallation

*Theexternalflexiblecableorcordofthislampcannotbereplaced

Ifthecordisdamaged,thelampshallbedestroyed

Part List and Hardware List

WARNING

WERECOMMENDINSTALLATIONOFTHISLIGHTINGFIXTUREBEDONEBYALICENSEDELECTRICIAN.

WARNING***SWITCHOFFTHEMAINELECTRICALSUPPLYFROMTHEMAINFUSEBOX/CIRCUIT

BREAKERBEFOREINSTALLATION.

INSPECTITEMCAREFULLYBEFOREATTEMPTINGTOINSTALL.IFTHEREISANYDAMAGEOR

OBVIOUSDEFECT,DONOTINSTALL.ITEMMAYNOTBERETURNEDONCEITHASBEENINSTALLED.

CARE AND MAINTENANCE

Tocleantheoutsideofthefixture,useadryorslightlydampenedcleancloth(usecleanwater,neverasolvent)towipe

thesurfaceofthefixture.

Tocleantheinsideofthefixture,firstdisconnectpowertothefixturebyturningoffthecircuitbreakerorbyremovingthe

fuseatthefusebox.Next,useadryorslighlydampernedcleanclorth(usecleanwater,neverasolvent)towipethe

interiorsurfaceofthefixture.

Donotuseanycleanerswithchemical,solventsorharshabrasives.Useonlyadrysoftclothtodustorwipecarefully.

NOTICE& IMPORTANT SAFETY INSTRUCTIONS

1/2

PAGE 1
WARNING WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN. WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION. INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL. ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
PAGE 2
PREPARATION Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product. Estimated Assembly Time: 20 minutes. 1. Determine the location for the lamp. Using the mounting plate (B) as a template, mark the location of the holes for the plastic anchors (I). 2. Drill the appropriate size holes for the plastic anchors (I).