Installation Guide

PIECE DESCRIPTION PICTURE

QUANTITY

PIECE DESCRIPTION PICTURE QUANTITY

mounting

screw

2X F body 1X

B mountingplate 1X G bulb 3X

C Screw 4X H plasticanchor 2X

D groundscrew 1X I woodscrew 2X

E wireconnector 3X

WARNING

WERECOMMENDINSTALLATIONOFTHISLIGHTINGFIXTUREBEDONEBYALICENSEDELECTRICIAN.

WARNING***SWITCHOFFTHEMAINELECTRICALSUPPLYFROMTHEMAINFUSEBOX/CIRCUIT

BREAKERBEFOREINSTALLATION.

INSPECTITEMCAREFULLYBEFOREATTEMPTINGTOINSTALL.IFTHEREISANYDAMAGEOR

OBVIOUSDEFECT,DONOTINSTALL.ITEMMAYNOTBERETURNEDONCEITHASBEENINSTALLED.

CARE AND MAINTENANCE

Tocleantheoutsideofthefixture,useadryorslightlydampenedcleancloth(usecleanwater,neverasolvent)towipe

thesurfaceofthefixture.

Tocleantheinsideofthefixture,firstdisconnectpowertothefixturebyturningoffthecircuitbreakerorbyremovingthe

fuseatthefusebox.Next,useadryorslightlydampenedcleancloth(usecleanwater,neverasolvent)towipethe

interiorsurfaceofthefixture.

Donotuseanycleanerswithchemical,solventsorharshabrasives.Useonlyadrysoftclothtodustorwipecarefully.

NOTICE& IMPORTANT SAFETY INSTRUCTIONS

Model#: JYL7544A

Product Dimensions: 24''W X 7"H X 4.75"E

*Pleasemakesurethatyouhaveallpartsindicatedbeforeyoubeginassemblyofthisitem

*Thisitemshouldbeassembledonasoftsurfacetopreventscratchingthefinishduringassembly

*Toreducetheriskoffire,electricalshockorinjurytopersonsorproperty,pleasefollowtheguidelinebelowforsafeuse

andinstallation

*Theexternalflexiblecableorcordofthislampcannotbereplaced

Ifthecordisdamaged,thelampshallbedestroyed

Part List and Hardware List

1/2

PAGE 1
WARNING WE RECOMMEND INSTALLATION OF THIS LIGHTING FIXTURE BE DONE BY A LICENSED ELECTRICIAN. WARNING *** SWITCH OFF THE MAIN ELECTRICAL SUPPLY FROM THE MAIN FUSE BOX/CIRCUIT BREAKER BEFORE INSTALLATION. INSPECT ITEM CAREFULLY BEFORE ATTEMPTING TO INSTALL. IF THERE IS ANY DAMAGE OR OBVIOUS DEFECT, DO NOT INSTALL. ITEM MAY NOT BE RETURNED ONCE IT HAS BEEN INSTALLED.
PAGE 2
PREPARATION Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and hardware contents list. If any part is missing or damaged, do not attempt to assemble the product. Estimated Assembly Time: 20 minutes. 1. Determine the location for the lamp. Using the mounting plate (B) as a template, mark the location of the holes for the plastic anchors (H). 2. Drill the appropriate size holes for the plastic anchors (H).