Manualshelf

Instructions / Assembly

ManualsBrandsJONATHAN Y ManualsLightingIrving 27.75 in. 4-Light Nickel Seeded Glass/Iron Modern Contemporary LED Vanity Light
12
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and
hardware contents list. If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 20 minutes.
1. Determine the location for the lamp. Using the mounting plate (B) as a template, mark the location of
the holes for the plastic anchors (J).
2. Drill the appropriate size holes for the plastic anchors (J). (the holes should be slightly smaller than
the size of the plastic anchors (J).). Install the plastic anchors (J) to the hole. Screw in the wood screw (K)
to the plastic anchors (J).
3. Fix the mounting plate(B) to the outlet box with mounting screw(A).
4. Make wire connections, with wire connectors(E), following the reference chart listed below.
Connect, Hot, Black or Red Outlet Supply Wire to:
Connect, Neutral, White Outlet Supply Wire to:
Black
White
* Parallel Cord (round & smooth)
* Parallel Cord (square & ridged)
Clear, Brown, Gold or Black without Tracer (colored stripes)
Clear, Brown, Gold or Black with Tracer (colored stripes)
Insulated Wire (not green) with copper metal conductor
Insulated Wire (not green) with Silver metal conductor.
*Note: When parallel wire ( SPT I & SPT II ) is used. The neutral wire is square shaped
and ridged and the hot wire will be round in shape and smooth. ( See Illustration on left. )
a) For installation in the United States: Wrap ground wire from outlet box around green
ground screw(D) on mounting plate, no less than 2" from wire end. Tighten ground screw. If
fixture is supplied with a ground wire, connect to outlet ground wire with a wire connector.
b) For installation in Canada: If fixture is supplied with ground wire, wrap ground wire
around green grounding screw on mounting bracket. Tighten ground screw.
5. Place the body (F) over mounting plate (B) and secure with retaining screw (C)
6. Put the glass shade(G) over the socket,then fasten it by socket ring(H)
7. Install bulbs(I). Be sure to use light bulb(s) with wattage no greater than specified on this
fixture. Always make sure that electrical current is turned off before changing bulbs.
PLEASE USE ON/OFF TYPE"A" BULB MAX 40-WATT OR CFL BULB MAX 13-WATT OR LED BULB 9-WATT
THERE ARE 4PCS 4-WATT LED BULB IN THE BOX
ENJOY YOUR LAMP
2/2