Instructions / Assembly

Option 2-The Downrod installation(continued)
10
5.Remove the hanger ball from the
downrod
6.Install Downrod and routing the
wires
C/D
G
PP
HH
Pin(CC3)
7.Assembling the fan
¨ Place the Coupling cover (F), Canopy
cover (E), and Canopy (B) over lead
wires and Downrod assembly (C/D).
Secure the Hanger Ball(CC2) with a pin
(CC1) and a set screw(HH).Tighten the
set screw to secure the Downrod
assembly(C/D).
G
WARNING: make sure the pin installed well
on hanger ball with downrod
F
E
B
C/D
Pin(CC1)
Set screw(HH)
NOTE: Equipped with two long and short
suspension rods (C) and (D) for installation
Choose one according to your own needs.
¨ Thread the top outlet wire of the Fan
Motor Assembly (G) through the Downrod
(C/D).
¨ Loosen but not remove the Set Screw
(HH) on the top motor ring (PP) of the fan
motor assembly (G) .
¨ Install the Downrod (C/D), insert the
Downrod (C/D) into the motor coupling
(PP), and secure it with a metal Pin (CC3).
Secure with R-shaped clips
¨ Tighten the Set Screw (HH) on the motor
ring (PP) again, so that the set screw (HH)
is firmly pressed onto the Downrod (C/D).
Hanger
Ball(CC2)
Set screw(HH)
Pin(CC1)
Hanger
Ball(CC2)
c
¨ Remove the Ball(CC2) from the Hanger
Downrod assembly(C) by loosening the
set screw (HH) and removing R-shaped,
the metal Pin (CC1)and Pin (CC3) as
shown. Keep parts.
NOTE: If lifting is required, skip steps 3-4;
if flushmount installation is required, skip
steps 5-8
Pin(CC3)
R-shaped