Instructions / Assembly

12
Assembly-Hanging the Fan(continued)
10.Install remote control
¨ Place the Receiver(L) on the Mounting
Bracket(A)
¨ Carefully push the Canopy(B) to the bottom
of the Mounting Bracket(A), make two
sliding holes aligned to the two prominent
screws on the Mounting Bracket(A), and
then turn clockwise until tight.
¨ Push the canopy ring to the bottom of the
Canopy(B), slide the inner holes aligned to
the two prominent screws on the Mounting
Bracket(A) again, and turn the canopy ring
clockwise until tight.
Canpoy(B)
Mounting
Bracket(A)
Bracket
screws(A1)
2
3
1
Receiver(L)
11.Attaching the blades to the arms
Red Washer(DD1)
Blade Attachment
Screw(DD2)
¨ Pass the Red Washer(DD1) through the
Blade Attachment Screw(DD2).
¨ Tighten the Screw(DD2) through the
Blade(I) and tighten it on the Arms(J).
¨ Repeat the above steps to tighten the
four sets of blades.
Blade(I)
Arm(J)
Fan-motor
Assembly(G)
¨ Fasten the arm to the Fan-motor Assembly(G) by
inserting the alignment post int the slot on the
bottom of the motor and tightening the pre-
instaled Arm Screws(GG).
¨ Repeat this step for the remaining blade
assemblies
Arm Screws(GG)
12.Fastening the blade arms to the
motor