Instructions / Assembly

6
Installation-Hanging the Fan
Installation - Hanging bracket
For wooden ceiling, use wood screw to drill
on the wooden beam or the "junction box" to
fix the hanging bracket (selection is made
according to actual requirements of the customers).
STEP 1A-WOODEN CEILING
SWITCH OFF THE ELECTRICAL MAINS AT THE CIRCUIT
BREAKER FUSE BOX.
1)Use the Mounting Bracket (A) as a guide, mark the spots
where the 2 Self Mounting Screws (AA) will be drilled.
2)Remove the Mounting Bracket (A), drill 2 holes for 3MM
diameter, install the mounting bracket onto wooden ceiling
with the 2 Self Mounting Screws (AA).
IMPORTANT :SCREWS MUST BE TIGHTENED TILL SNUG
STEP 2A-CONCRETE CELING
SWITCH OFF THE ELECTRICAL MAINS AT THE CIRCUIT
BREAKER FUSE BOX.
1)Use the Mounting Bracket (A) as a guide, mark the spots
where the 2 Expansion Bolts(BB) will be drilled.
2)Remove the Mounting Bracket (A). Drill 2 holes for 8MM
diameter and insert 2 Expansion Bolts (BB) into the concrete
ceiling, install the mounting bracket and secure with Flat
Washers(BB1), Spring Washers(BB2)and Nuts(BB3)
IMPORTANT :SCREWS MUST BE TIGHTENED TILL SNUG
For concrete ceiling, use the percussion bit with
diameter 8mm to drill holes according to the
length of expansion screws. Then use the attached
expansion screws to fix the hanging bracket onto
the ceiling (selection is made according to actual
requirements of the customers)
Mounting
Bracker(A)
Expansion
Bolts(BB)
Flat Washers(BB1)
Spring washers(BB2)
Nuts(BB3)
Mounting
Bracker(A)
Mounting Screws(AA)
14"
19"
24"