Instructions / Assembly

8
Assembly1-Standard Ceiling Mount
1.Preparing for standard mounting
¨ Loosen the two Bracket screws (A1)
located on the bottom of the mounting
bracket (A), and turn the canopy counter
clockwise to remove the mounting
bracket (A) from the canopy(B).
NOTE: The magnet is pre-attached on the
canopy bottom cover for you to remove and
install easily.
Canpoy(B)
Mounting
Bracket(A)
Bracket
screws(A1)
2.Attaching the fan to the electical
box
¨ Pass the 120-Volt supply wires through
the center hole in the slide-on mounting
bracket (A).
¨ Install the slide-on mounting bracket (A)
on the outlet box by sliding the slide-on
mounting bracket (A) over the two
screws(CC) provided with the outlet
box. lf necessary, use leveling washers
(not included) between the slide-on
mounting bracket(A) and the outlet box.
The flat side of the slide-on mounting
bracket (A) should face toward the
outlet box, as shown.
¨ Securely tighten the two mounting
screws (CC).
NOTE: The mounting bracket (A)is designed
to slide intoplace on an outlet box with the
outlet box screws(CC)
WARNING: To reduce the risk of fire, electric
shock or personal injury, mount to an outlet
box marked “Acceptable for fan support of
35 lbs.(15.9 kg) or less," and use the screws
provided with the outlet box.
CC
CC
A