Instructions / Assembly

Assembly-Standard Ceiling Mount(continued)
9
Option 1-Flushmount installation (continued)
Canpoy(B)
Mounting
Bracket(A)
4.Flushmount Installation
¨ Slide the canopy up into place over
the ceiling Mounting Bracket (A).
Loosen up the canopy screws on the
side of the canopy screws. Press the
Canopy(B) against the mounting
bracket and turn it clockwise.
Tighten screws on the J Slots and
install the two screws in the
remaining holes.
NOTE: Before installing the canopy, wire it
first, refer to step 9 on page 11 for wiring
reference
Canopy(B)
Support Rod
Coupler(PP)
Mounting
Screws(II)
3.Install flushmount assembly
NOTE: If lifting is required, skip steps 3-4;
if flushmount installation is required, skip
steps 5-8
Mounting
Screws(II)
Support Rod
Coupler(PP)
Set Screws(HH)
¨ Loosen the Set Screws(HH) in the
Support Rod Coupler(PP) located on
the top center of the motor housing until
the inside channel is clear.
¨ Remove and save the larger three
mounting screws (II) from the
connector.
¨ Place the Canopy(B) on the top of the
motor housing, align the three small
holes of the Canopy (B) with the holes
where the screws were just removed,
and secure with the three Mounting
Screws(II).