Installation Sheet

CARE INSTRUCTIONS

To clean, wipe gently with a soft, damp cloth, then wipe dry. To ensure long

lasting luster, harsh abrasives or polishes should be avoided. Your specific

model may vary.

INSTALLATION INSTRUCTIONS

Before beginning the installation, determine your needs, and if necessary

consult the store where you purchased your faucet for valve and adapter

recommendations.

BEFORE STARTING THE PROJECT, SHUT OFF HOT AND COLD WATER SUPPLIES.

If you are removing an existing faucet, remove the faucet from the sink and clean sink thoroughly.

STEP B: CONNECTING THE SPRAY HOSE

From beneath the sink, connect the hose to the short tube’s end

fitting. Tighten the screw on the connector, be sure to secure the

end of the tube from twisting while tightening, assemble the two

halves of the balance weight onto the spray hose (see picture

for placement location). Pull spray hose back and forth to check

for smooth operation. Attached pull-out spray head to hose. Be

sure included washer is inside hose.

STEP C: CONNECTING THE SPRAY TUBES

Hot supply tube is indicated with a red mark. Attach water

supply lines (sold separately) to faucet lines and valves. Use

a wrench to hold the copper faucet lines in place when

tightening supply lines. This will help prevent twisting and

kinking. Tighten firmly (careful not to over-tighten) until a seal

is achieved.

STEP D: FLUSH AND CHECK FOR LEAKS

Turn on hot and cold water supplies; cheak for leaks. Remove the pull-out spray head from the

house. Point the hose into the drain and turn on the faucet, hot and cold mixture, for 1 minute.

Re-attach the spray head to hose. Run water again and check all connection for leaks.

SINGLE HOLE SINK (Without escutcheon)

1. Set the faucet into the sink hole.

2. From underneath the sink, first, slide the mounting gasket, second, slide

the metal mounting washer and finally, the seat nut (with screws facing

downward) up the hoses to the threaded shank. Thread the nut up to the

sink. Do not tighten down the screws until the faucet is aligned properly.

The faucet is aligned properly when the spout travels the same distance,

side to side. Once it is aligned, tighten the seat nut screws.

STEP A: FAUCET INSTALLATION

PULL OUT & PULL DOWN KITCHEN FAUCETS

INSTALLATION INSTRUCTIONS

PAGE 1
PULL OUT & PULL DOWN KITCHEN FAUCETS INSTALLATION INSTRUCTIONS STEP B: CONNECTING THE SPRAY HOSE CARE INSTRUCTIONS To clean, wipe gently with a soft, damp cloth, then wipe dry. To ensure long lasting luster, harsh abrasives or polishes should be avoided. Your specific model may vary. From beneath the sink, connect the hose to the short tube’s end fitting.
PAGE 2
Limited Lifetime Warranty: Your Jones Stephens faucet has been designed and manufactured to high quality standards and therefore we warranty it against defects in material or workmanship for as long as it is owned by the original purchaser. Jones Stephens will provide repair parts or replace any faucet which proves defective due to materials or workmanship. Please have a copy of your purchase receipt along with the model number. Contact us at Jones Stephens, 3249 Moody Parkway, Moody, AL 35004 or 1.800.355.