Workshop Manual

43
4
502 51 67-01
1
2
3
4
5
6
7
1
2
3
A
Fuel system
Lift up the carburettor and remove the air
filter holder, throttle push rod and fuel
pipe.
Fitting mod. 2077/2083
Fit the carburettor in the reverse order to
dismantling.
Dismantling mod. 2095
Dismantle the covers so that the car-
burettor becomes accessible.
Unscrew the carburettor screws and pull
them out approx. 15 mm.
Tilt and push the carburettor sideways to
the right until the screwdriver guide
releases from the carburettor’s adjusting
screws.
Lift up the carburettor and remove the air
filter holder, throttle push rod, and fuel
pipe.
Fitting mod. 2077/2083
Fit the carburettor in the following order:
1. Connect the fuel pipe.
2. Connect the throttle push rod.
3. Connect the impulse pipe.
4. Place the air filter holder in position
and push the carburettor screws
completely in the carburettor so that
they are visible and thereby simplifing
centring to the suction pipe.
5. Press down the throttle push rod’s
guide in the crankcase.
6. Tighten the carburettor screws.
7. Connect the choke lever.
8. Fit the air filter.
Unscrew the carburettor screws and pull
them out approx. 15 mm.
Tilt and push the carburettor sideways to
the right until the screwdriver guide (A)
releases from the carburettor’s adjusting
screws.
Dismantling mod. 2095
Dismantle the carburettor cover, air filter
cover and cylinder cover, and then:
1. The impulse pipe.
2. Fuel pipe.
3. Choke lever.