Use and Care Manual

SERVICE AND ADJUSTMENTS

• Wrap V-belt around reverse idler pulley and reassemble

idler to idler arm. Tighten securely. Be sure belt is

between reverse idler pulley and idler arm pin.

• Install belt to outside groove of transmission pulley. Be

sure belt is inside all belt guides and rests on outside

groove of engine pulley.

CHECK TINE OPERATION

• See “TINE OPERATION CHECK” in this section of

manual.

REPLACE BELT GUARD

Fig. 22

FORWARD MOTION

(INSIDE) V-BELT

ENGINE PULLEY

BELT GUIDE

REVERSE IDLER ARM

REVERSE IDLER PULLEY

IDLER ARM PIN

TRANS MIS SION

PUL LEY

FOR WARD IDLER PUL LEY

REVERSE (OUTSIDE)

V-BELT

BELT GUARD BOLT

ENGINE

TO AD JUST CARBURETOR

The carburetor has been preset at the factory and cannot

be adjusted.

IMPORTANT: NEVER TAMPER WITH THE ENGINE GOVERNOR,

WHICH IS FACTORY SET FOR PROPER ENGINE SPEED. OVER-

SPEED ING THE ENGINE ABOVE THE FACTORY HIGH SPEED

SETTING CAN BE DANGEROUS. IF YOU THINK THE ENGINE-

GOVERNED HIGH SPEED NEEDS ADJUSTING, CONTACT YOUR

NEAREST AUTHORIZED SERVICE CENTER/DEPARTMENT,

WHICH HAS THE PROPER EQUIP MENT AND EXPERIENCE TO

MAKE ANY NEC ES SARY ADJUSTMENTS.