Owner Manual

ManualsBrandsJonti-Craft ManualsLockersYoung Time® 2 - Tier 48'' Wide Locker

DHCJW – Rev. B – 23 October 2019

800-543-4149

507-342-5169

www.jonti-craft.com Page 1 of 4

JonTi-Craft, Inc.

171 Hwy 68

P.O. Box 30

Wabasso, MN 56293

WARNING:

CHOKING HAZARD/SHARP POINTS- Assembly

hardware contains small parts and components

with sharp points. Adult assembly required.

Attention: This unit must be attached to a wall to

prevent tipping over!!

Hardware Illustrations

Not Actual Size

Tools Required:

-4mm Hex Wrench, (Provided)

-Medium Phillips Screwdriver

Instructions for:

7104YT Coat Locker, Wall, 10-Section

Hardware Package HCJW

Qty. Description

(1) XAUS 4mm Hex Wrench

(12) XAUR 2" Decorative Screw

(3) XCPT #8 X 0-7/8” washerhead Screw

(10) XBTX #6 X 0-5/8" Trusshead Screw

(3) XAFH #8 X 3” Drywall Screw

(2) XAEB #6 X 1-1/4” Drywall Screw

(5) XCLX Nylon Coat Hook

Parts:

Summary of content (4 pages)

PAGE 1
WARNING: CHOKING HAZARD/SHARP POINTS- Assembly hardware contains small parts and components with sharp points. Adult assembly required. Attention: This unit must be attached to a wall to prevent tipping over!! Tools Required: -4mm Hex Wrench, (Provided) -Medium Phillips Screwdriver Instructions for: 7104YT Coat Locker, Wall, 10-Section Hardware Illustrations Hardware Package HCJW Qty.
PAGE 2
Assembly Instructions: 1. Place Hook Rail-G on flat surface and install 5-XCLX Coat Hooks with 10-XBTX Screws using Phillips Screwdriver. Note location of rounded edge in respect to hook placement. Set aside for installation later. 2. Install Top-C, Bottom-A, and Shelf-B to LH Side-D by aligning dowels. Ensure back grooves all align and rounded edge of shelf is down. Secure with 6-XAUR Decorative Screws with 4mm Hex Wrench provided. 3. Install RH-Side-E by aligning dowels.
PAGE 3
4. Drop in 8-Hardboard Dividers-J into groves with rounded edge down. 5. Insert 2-Backs-I by inserting into LH Side groove on one end, bowing into other groove on opposite end, and sliding into full length grooves on Top and Bottom. 6. Install Hanging Bracket-F and Hook Rail-G by aligning dowels. Ensure Backs (previously installed) are seated into Top, Bottom, and Side grooves. Note location and orientation of mitred edge of Hanging Bracket and hooks on Hook Rail.
PAGE 4
7. Locate predrilled holes in middle shelf and install 3-XCPT Washer head Screw with Phillips Driver. 8. Instructions for Wall Mounting: a) After selecting the location and mounting height on the wall, determine the positioning of the wall studs and attach the Wall Mounting Bracket-H to the wall studs using included 3-XAFH 3” Drywall Screws (note orientation of mitre of wall bracket in diagram below). NOTE: Wall mounting bracket must be secured to at least two wall studs.