Owner Manual

DHCJW – Rev. B – 23 October 2019
800-543-4149
507-342-5169
www.jonti-craft.com Page 3 of 4
JonTi-Craft, Inc.
171 Hwy 68
P.O. Box 30
Wabasso, MN 56293
4. Drop in 8-Hardboard Dividers-J into groves with rounded edge down.
5. Insert 2-Backs-I by inserting into LH Side groove on one end, bowing into other groove on
opposite end, and sliding into full length grooves on Top and Bottom.
6. Install Hanging Bracket-F and Hook Rail-G by aligning dowels. Ensure Backs (previously installed)
are seated into Top, Bottom, and Side grooves. Note location and orientation of mitred edge of
Hanging Bracket and hooks on Hook Rail. Tighten 6-XAUR Decorative Screws previously installed.