Owner Manual

DHCJW – Rev. B – 23 October 2019
800-543-4149
507-342-5169
www.jonti-craft.com Page 4 of 4
JonTi-Craft, Inc.
171 Hwy 68
P.O. Box 30
Wabasso, MN 56293
7. Locate predrilled holes in middle shelf and install 3-XCPT Washer head Screw with Phillips Driver.
8. Instructions for Wall Mounting:
a) After selecting the location and mounting height on the wall, determine the positioning of the
wall studs and attach the Wall Mounting Bracket-H to the wall studs using included 3-XAFH 3”
Drywall Screws (note orientation of mitre of wall bracket in diagram below).
NOTE: Wall mounting bracket must be secured to at least two wall studs.
b) Lift the Wall Locker up into position above the wall mounted bracket and allow the unit to slide
down into position on the wall mounted bracket.
c) Finish securing the unit by inserting 2-XAEB 1-1/4” Drywall Screws through the back of the
unit and into the wall mounting bracket secured to the wall. This step will ensure that the unit
will not lift off the wall mounted bracket.
9. If you experience any difficulties when assembling this product, please contact the Jonti-Craft
Customer Relations Team at [phone] or [e-mail]. All other requests for
assistance must be directed to your Jonti-Craft Dealer.
General Care & Maintenance Guidelines: www.jonti-craft.com/generalcare