Installation Manual

Table Of Contents

is connected to the Internet. Steps for setting are presented as follows:

1.Connect the equipment to a router that is connected to the Internet through the

Ethernet Cable;

2.Click the right button to select Network settings on the DVR menu for entering the

interface of network setting and setting Network. After that, check DHCP Enable to

make DHCP not enable and click Application;

Select Phone APP in the interface of network settings and click Cloud1; When Nat

status is displayed Connected, it indicates that the equipment is accessed to the

Internet. If Connecting is displayed, the equipment is not connected to the equipment;

At this time, please reboot the DVR for checking. If Connecting is remained, please

return to the interface of Network to close the DHCP Enable and manually modify

the IP address and Gateway (if the IP address of the router is 192.168.1.1, you can set

the IP Address of the equipment to be 192.168.1 .X; X can be any number of 2-255

and Gateway is 192.168.1.1) of the router.

PS: Danale app is for cloud1, and XVR app for cloud2.