Use and Care Manual
HARD-STONE LAPIDARY ADD-ON KIT: Item# K-1001 (Hard Stones: Mohs 7 +) ALSO WORKS ON SOFT STONES (as on p.19)
FOR CABOCHONS AND FLAT PIECES
TO REMOVE SCRATCHES OR CHIPS
STEP 2
REFINE the shape and
remove scratches:
Use 3M Microfinishing Diamond
abrasives to nalize the shape and
remove any leftover scratches.
Speed: Medium-High speed with water
STEP 3
PREPARE your piece for POLISHING
Prepare your piece for nal polish
using 3M Premium Diamond abrasives,
the brown discs.
Speed: Slow Speed (with lots of water)
Pressure: Use gentle, consistent pressure.
STEP 1
GRIND and SHAPE your piece
Use 3M Flex-Diamond (COARSE ) abrasive
Speed:High speed with water
FLEX DIAMOND DOES NOT NEED A CUSHION
1
FINAL STEP HIGH-POLISH your piece.
Use 3M Cerium Oxide to get a final polish
WARNING: Do NOT use on porous surfaces
Speed: Slow (with lots of water)
Pressure: Use Use gentle, consistent pressure.
4
ALTERNATE FINAL STEP: POLISHING
Some stones polish easily with our FELT DISC
Try this after step 1b on Turquoise, Opal, etc.
Speed: High Speed. DO NOT USE WATER
ALTERNATE STEP
4
LAPIDARY MINERAL CRYSTAL HARD GLASS
Toll Free: 1-85-JOOLTOOL p.18 Buy supplies at WWW.JOOLTOOL.COM
CLEANING: Clean abrasives with damp cloth for longer life & performance.
Repairing scratched or chipped pieces is similar to working on raw (rough) material.
For DEEP Scratches: Start at Step 2c, then continue up to FINAL STEP.
For LIGHT scratches: Start at Step 3a, then continue up to FINAL STEP. Also try ALTERNATE FINAL STEP.
FELT DISC
Item# B-301
2
3
This 4-Grade Kit Item# K-3600-4This 4-Grade Kit Item# K-3650-5
Apply COMPOUND on FELT DISC
Item#: C-103
SOLD SEPARATELY
FOLLOW FROM
TOP TO BOTTOM
X Coarse
Item# D-36250-1
1
Coarse
Item# D-3074-2
2a
Medium
Item# D-3045-2
2b
Fine
Item# D-3030-2
2c
Very Fine
Item# D-3020-2
2d
3000 Grit
Item# D-33000
3a
8000 Grit
Item# D-38000
3b
50 000 Grit
Item# D-50000
3c
FINAL STEP:
Cerium Oxide
Item# AT-13000-2
4
Apply CUSHIONS to BACKPADS.
FLEX DIA. & FELT don’t need cushions.
Apply abrasives onto BACKPADS
(with the CUSHIONS applied).
Use Water Tray to apply water to the
workpiece during every step.
SETUP
!
SAFETY FIRST!
Always wear eye
and respiratory
protection.
1
2
3
ANIE’S TIP: To avoid scratches on nished piece, follow ALL steps THOROUGHLY & inspect your piece after each step.