Use and Care Manual

ABRASIVES, BACKPADS & CUSHIONS
Remove all protective film from new ABRASIVE before applying it onto the BACKPAD.
NOTE: Adhesive cures rapidly when ABRASIVE is applied onto BACKPAD.
ANIE’S TIP: At first, apply the ABRASIVE very lightly onto the BACKPAD. This will give you the
opportunity to make corrections and adjust the SEE-THRU™ pattern alignment if necessary
before the adhesive cures. Press firmly to adhere when the SEE-THRU™ alignment is correct.
HOW TO REMOVE LEFTOVER ADHESIVE FROM BACKPAD: When changing worn abrasives,
you can leave the leftover adhesive on the BACKPAD as the new abrasive will likely fuse
with it upon use. If you prefer a clean surface, you can remove leftover adhesive by
dabbing with the sticky side of your old abrasive or sticky tape. Do NOT use solvents!
ALWAYS change ABRASIVE if it is damaged, torn or is excessively worn.
3M recommends to DISCARD an abrasive once it’s been removed/unstuck from the BACKPAD
as the ADHESIVE on the Abrasive is designed for SINGLE APPLICATION ONLY.
Failure to follow this rule can potentially cause property damage and/or personal injury!
NEVER use an ABRASIVE if it is not adhering to the BACKPAD.
NEVER apply ABRASIVES on BACKPAD when wet.
NEVER use disc if the ABRASIVE has been improperly installed onto the BACKPAD.
Improperly installed abrasive increases risk of property damage and/or personal injury!
NEVER cut, change, or distort the shape of the SEE-THRU ™ design on the abrasive.
ALWAYS place abrasive on the FLAT (BOTTOM) surface of the BACKPAD.
ALWAYS install abrasives on the BACKPAD by aligning correctly with the SEE-THRU™ design.
ALWAYS press firmly to ensure full adherence between ABRASIVE and BACKPAD.
HOW TO SETUP
ALWAYS turn JOOLTOOL “OFF” before installing/changing BACKPADS or ACCESSORIES.
NEVER install BACKPADS while the motor is “ON”. This can cause personal injury.
The motor rotation is COUNTER CLOCKWISE
Use for ABRASIVES that require CUSHION BACKING
(ex: Polishing Diamond, Trizact™ and other FINE Abrasives)
ALWAYS apply CUSHIONS BEFORE applying ABRASIVES.
ALWAYS remove all protective film from CUSHIONS
before applying it onto the BACKPADS.
ALWAYS apply CUSHIONS to flat surface of BACKPADS.
NOTE: DO NOT APPLY CUSHIONS UNDER FELT DISC OR SCRATCH-ERASER ABRASIVES.
ALWAYS install BACKPADS with ABRASIVE side DOWN.
ALWAYS tighten your BACKPADS snuggly onto the spindle before use.
ALWAYS use GENUINE JOOLTOOL™ BACKPADS & ORIGINAL spindle.
This will guarantee that your discs will be perfectly centered and give you optimal results.
NEVER use third-party (non-JOOLTOOL™ brand) Spindles.
NEVER use damaged or cracked BACKPADS as they may break apart during use, potentially causing injury.
NEVER place workpiece on top or the side of spinning disc. The disc can eject workpiece and may cause loss of control.
ALWAYS Turn the Jooltool “OFF” if excessive vibration occurs during use. See “TROUBLESHOOTING” p.28
ABRASIVE
(CUSHION)
BACKPAD
!
1
2
3
!
CUSHIONS - SETUP & SAFETY
ABRASIVES - RECOMMENDED SETUP & SAFETY
Toll Free: 1-85-JOOLTOOL p.8 Buy supplies at WWW.JOOLTOOL.COM