Troubleshooting Guide

3. Can not login the system interface with “192.168.10.1”
I. Enter "192.168.10.1" to enter the menu interface when using "repeater mode".
II. Enter "192.168.1.x" (depends on the IP you set earlier in step 3) to enter the menu
interface when using "ap mode".
4. How to reset this device:
Reset method:
1. Unplug it and power it again, wait 60s.
2. Then press the reset hole by a slim stick for 10s till the blue lights are all off. （You
will see the blue lights flash on and off for 3-4 times when holding pressing, and then
all are off)
3. Last, wait till the "JW-EW74" signal appears on your wifi list, now begin to set it.
5. How to make your PC access each other:
In the configuration wizard page of AP mode, modify the LAN port IP to the IP
segment of the current intranet. At the same time, set the computer or mobile
phone to a static IP address, and the same network segment as the current intranet,
so that the devices can be accessed each other. For example: your intranet IP is:
192.168.0.1, you can set the access point's LAN port IP in ap mode to: 192.168.0.2,
after the setting is successful, you will need to use "192.168.0.2" to log in to the main
menu in the future page. Then your laptop and desktop computer can set static IP
address: 192.168.0.3 and 192.168.0.4
Note: In the ap mode, the LAN port of the device is modified to the same network
segment as the computer (a static IP address is recommended), so that the computer,
laptop and the other device can access each other.
6. How to check the "terminal device's IP address" and "traffic statistics"?
I. In AP mode, IP address of the terminal equipments are not assigned by AP, so the
AP cannot show their IP address. All the IP management work are completed by your
superior routing and you can check them on your superior router.
II. At the same time, this device can not count traffic statistics since the data does not
pass through the device firewall in AP mode. The AP is like a WiFi extender, and the
management work is done by the superior routing.
If you set repeater mode, then you can check the IP address and traffic statistics on
this device.