. Installation diagram of network cable: (1) Thread the network cable through the screw bottom cover. (2) Thread the network cable through the sealing ring. (3 Thread the network cable through the trestle. @ Connect the network cable to the LAN/WAN port of the device. (a5) POE Adapter LAN/WAN Computer 2. The device defaults to "Repeater Mode" after the first login or reset. The steps to enter the device manage page: {1)Power on and wait about 80 seconds for the device to start up.
Select the "Wizard", there are four working Modes: AP, Bridge, Router, and Repeater mode. It is recommended to select AP mode. Internet Internet Lo Hoe Router Internet Internet (n) sem | P(e SWITCH WISP AP Repeater APF Mode: AP mode and set the intranet IP address. For example, your superior router IP is 192.168.1.1. In AP mode, the IP of the device should be set as follows. 192.168.1.2 {Cannot conflict with other devices) @Q—0 Wireless Finish + Lan Settings IP Address 182.168.
@ > Wireless Finish 2.46 Wireless S810 JOOWIN-EWT4 Password Country 2 Ag Bandwidth 246 Channel 5.86 Bandwidth 5.86 Channel Bridge mode and set the intranet IP address. For example, your superior router |P is 192 .168.1.1. In Bridge mode, the IP of the device should be set as follows. 192.168.1.2 (Cannot conflict with other devices) © Finish ~ Lan Settings IP Address 182.168.1011 Subset Mask = 2552582550 4-2 Select 2.46 or 5.
Scan Results NO. 85510 550 Channel Operation ADAS ER BEARS Unknown AAS ERA DYES unknown AAS EER 4B ZL unknown COEQUAL BL 96D] A00WmaG AVAILABLE EE] Unknown A0A5 EF BEDEVIL Unknown A0ASERBO0T.36 EILEEN 809736 (Please connect the LAN port of the device and the LAN port of the modem with network cable). There are three ways to access the Internet, namely "Popper, "Static’, "DHCP". It is recommended to choose Poe: 5-electable Router mode, choose Poe. 5-2) Enter your Internet account name and password.
"Repeater mode”. 2 4G or 5.8G band, click scan and it will find the nearby wireless SAID, select your wireless SAID and enter its password. 0 Wireless Finish ~ Repeater Selling Scan Band 5510 Password an independent password for your extended WiFi (it is recommended that the password is the same as the WiFi password of the superior router}, and Click Finish.
{ EC CLE CE "Repeater mode” and use default IP 192.168.10.1 2.4G or 5.8G band, click scan and it will find the nearby wireless SAID, select your wireless SAID and enter its password. © Finish Repeater Settings Scan Band S510 Password an independent password for your extended WiFi (it is recommended that the password is the same as the WiFi password of the superior router), and Click Finish.
Reset method: Unplug the device and then plug it again, wait for 90 seconds, then press and hold the reset hole with a thin stick for 10 seconds until the blue light goes out. (when you press and hold, you will see the blue light flash 4-5 times and then go out), wait for the system to restart (about 2 minutes). Wait the "WINNOW EWE" WiFi appears in the WiFi list on the computer/mobile phone, now you can start to setup.
