User's Manual

Jotron AS| TR7750C: Operators Manual  Operating Instructions
Page 5-17
P/N: 84748 (G)
Menus for user level: Technician
For details regarding submenus, refer to chapter 5.4.
Menus for user level: SysOp
For details regarding submenus, refer to chapter 5.4.
Table 5.7-1, User menu selections receiver - Operator, Technician and SysOp access levels
5.8 Setting, information and configuration menus – receiver
Under the menu selection from the user menu, various submenu groups are available depending on
the user level.
The submenus and details for them are shown in the tables below.
Submenu
Access level
Description
Radio control ►
SysOp, Technician
Access to operation mode, low power level, climax offset
parameters, modulation and standby settings.
RX config ►
SysOp
Access to configuration parameters for modulation, audio
settings, Squelch settings and internal calibration settings.
Interface config ►
SysOp
Access to configuration parameters for the ethernet
interface, RS232 port, RS485 port, various pin settings on
the hardware interface (remote connectors) and the user
access level.
Bite system ►
SysOp, Technician
Displays information about active alarms and gives the
user access to internal measurements.
System info ►
All
Displays information about the firmware and hardware
release, system up-time and radio identification
Table 5.8-1, Submenus available on the receiver