Installation Manual Part 2
Table Of Contents
- 8 Installation
- 8.1 Mechanical Mounting
- 8.2 Cabling
- 8.3 Wiring and Connections
- 8.3.1 Transponder
- 8.3.1.1 Pictorial display of typical connections to the transponder
- 8.3.1.2 Label in transponder with connection tables
- 8.3.1.3 Power connection
- 8.3.1.4 Sensor connections
- 8.3.1.5 External display – ECDIS/Radar connections
- 8.3.1.6 Pilot / Aux. Display connection
- 8.3.1.7 Alarm Connection
- 8.3.1.8 Detailed description of connections, fuses, factory reset etc.
- 8.3.2 Display Unit:
- 8.3.1 Transponder
- 9 Initial configuration
- 10 Operation Instructions
TR-8000 Operator and Installation Manual 53
8.3.1.3 Power connection
Table showing connection of main and backup power
See also figure Figure 8-10
Allowed voltage levels of the power supply to be connected with the transponder:
Minimum = 10.8 volt
Maximum = 31.2 volt
Recommended cable diameter: 2.5 – 4 mm
2
Connection
Function
P1
GND (Chassis)
P2
MAIN 0V
P3
MAIN 12 - 24 VDC
P4
GND (Chassis)
P5
BACKUP 0V
P6
BACKUP 12 – 24 VDC