User's Manual

84145_UM_ SART20_B 21
6.2.1
REPLACING THE BATTERY MODULE
Refer to Figure 3.1 and do the following steps:
1. Open the transponder by turning the screw ring counter clockwise.
2. Remove the rubber gasket.
3. Slide out the battery module and disconnect the battery connector.
4. Ensure the silicagel bag and anti corrosion tape supplied with the battery are fitted to inside of
Tron SART20.
5. Connect the new battery module and slide it into the Tron SART20 housing.
6. Insert rubber gasket.
7. Tighten the screw ring by turning it clockwise.
8. Test the transponder according to procedure in chapter Feil! Fant ikke referansekilden..
6.2.2
BATTERY DISPOSAL
Dispose in accordance with applicable regulations, which vary from country to country.(In most countries,
the disposal of used batteries is regulated and end-users are invited to dispose of them correctly, through
non-profit organizations, mandated by local governments or organized on a voluntary basis by
professionals).Lithium batteries should have their terminals insulated prior to disposal.
6.2.3
INCINERATION
Incineration should never be performed by battery users but by trained professionals in authorized
facilities with proper gas and fumes treatment.
6.2.4
LAND FILLING
Leachability regulations (mg/l)
Component Leachability EC
limit
EPA Other*
Iron
Nickel
100
100 500 2
5
0,5
* Applicable to France
6.2.5
RECYCLING
Send to authorized recycling facilities, through a licensed waste carrier.