Operation Manual
14
4.5 Fitting a ue pipe with a top outlet
The product is supplied from the factory with the smoke outlet
tted for the top outlet.
Fig. 10
A
B
1. Thread the ue pipe (A) through the top plate and place it
in the top smoke outlet.
2. Seal well with a gasket (B).
4.5 Performance chec
Always check the control handles once the product has
been assembled. These should move easily and work in a
satisfactory manner.
Fig. 11
A
B
The Jøtul F 520 is equipped with the following
operating options:
Pull out the ignition vent (A) the air vent (B) automatically follows.
4.6 Mounting of ash lip
5.0 Daily use
Odours when using the replace for the
rst time
When the replace is used for the rst time, it may emit an
irritating gas which may smell slightly. This happens because
the paint dries.The gas is not toxic but the room should be
thoroughly ventilated. Let the re burn with a high draught
until all traces of the gas have disappeared and no smoke or
odours can be detected.
Heating advice
NB: Logs that have been stored outdoors or in a cold room
should be brought indoors 24 hours before use to bring them
up to room temperature.
There are various ways of heating the stove but it is always
important to be careful about what you put in the stove. See
the section on “Wood quality”.
Important! An inadequate air supply can lead to poor
combustion, high emissions and a lower level of efciency.
Wood quality
By quality wood we mean most well-known types of wood
such as birch, spruce and pine.
The logs should be dried so that the moisture content is
no more than 20%.
To achieve this, the logs should be cut during the late winter.
They should be split and stacked in a way that ensures good
ENGLISH