Operation Manual

ManualsBrandsJotul ManualsAir ConditioningGf 3

Figure 18.

The thermo-

couple and

thermopile

should be fully

engulfed by the

pilot flames.

1

(25mm)

3/8

(8mm)

Min.

1/8

(3mm)

Min.

Figure 17.

Proper pilot flame /

carry-over port

alignment.

Adjusting the Burner

Burner adjustments must only be performed by qualified

personnel. To adjust the air supply, regulate the air opening

in the burner tube right above the connection of the gas

supply. See fig. 19. Loosen the wingnut under the stove and

adjust the air opening by pulling the air shutter to the

correct opening. See fig. 20.

For Natural Gas: 9.6 mm (this dimension is preset at the

factory)

For Propane: 12.6 mm (this dimension is with shutter fully

open)

Note! To avoid burns, do not adjust the air shutter

until the burner has cooled down.

Safety Switch

Jøtul GF 3 CF2 is equipped with a safety switch. See fig. 16,

page 10. This switch stops the gas supply to the appliance

if there is a blockage in the vent system. Look for obstruc-

tions in the vent system (such as bird’s nests, or branches

from bushes and trees). If necessary, call for service.

Annual Service

Annual service of the appliance includes the following

check points.

 Lighting the pilot flame

 Cleaning the glass.

 The gasket around the glass must be inspected

annually for wear and replaced if necessary.

 Check if the textured embers need to be replaced.

 Look for soot. It could be a result of the ceramic logs

not being centered in the oven and completely pushed

onto the metal plate, or the air regulator has been

adjusted incorrectly. (see section: Adjusting the

burner)

 Check the gas pressure if other gas equipment is

connected to the gas supply.

 Look for signs of corrosion on the appliance and the

vent system.

 Look for obstructions in the vent system (such as

bird’s nests, or branches from bushes and trees).

Regulating the Pilot Flame

The pilot flame should have three flames as shown in fig.

17. The two thermo-element sticks should be surrounded by

two of the flames as shown in fig. 18.

The flames should be stable and the colour mainly blue. If

you detect a deviation from this, turn off the pilot flame

and call for service.

Air Shutter

fully open for

G31

13 mm

Figure 19. Air Shutter Adjustment.

Figure 20. Loosen wingnut to adjust air shutter..

FULLY

OPEN

for

G 31