User manual

®
Known Problems / Solutions
Unfortunately it does occur at times that the RAM modules get loose,
Failure: Display does not react when switched on and the PC may peep.
Instructions to eliminate this failure:
1. Remove the power cable from the power supply
2. Then press the power switch button again
3. Remove the left casing cover (with the ventilation slits)
4. Localise the RAM modules, they are usually on the mainboard in the upper right field.
5. Now touch a metal part of the casing to discharge possible static charge.
The PC may otherwise be damaged by static charge!
6. Remove the RAM module by pressing both catches on the right and left of the RAM outwards.
7. Now press the RAM modules back into the inserts, they automatically catch into the RAM and
lock it.
8. Check that the catches are correctly locked into the recesses of the RAM, if this is not the case
the RAM has to be pressed further into the memory slot.
9. Reassemble the side panel and connect the power supply cable again.
Should the failure not have been eliminated, please contact the dealer from whom you bought the
system. (see following page)