Instructions

ManualsBrandsJoy-it ManualsBreakout BoardsJoy-it COM-MOSFET Voltage transformer 1 pc(s)

www.joy-it.net

Pascalstr. 8 47506 Neukirchen-Vluyn

FIELD-EFFECT TRANSISTOR FOR

CONTROLLING HIGHER VOLTAGES

COM-Mosfet

1. GENERAL INFORMATION

Dear costumer,

thank you very much for choosing our product.

In following, we will introduce you to what to observe while starting up

and using this product.

Should you encounter any unexpected problems during use, please do

not hesitate to contact us.

The maximum permissible input voltage is 36 V.

The maximum permissible operating current is 2 A.

Never exceed these limits.

Summary of content (4 pages)

PAGE 1
FIELD-EFFECT TRANSISTOR FOR CONTROLLING HIGHER VOLTAGES COM-Mosfet 1. GENERAL INFORMATION Dear costumer, thank you very much for choosing our product. In following, we will introduce you to what to observe while starting up and using this product. Should you encounter any unexpected problems during use, please do not hesitate to contact us. The maximum permissible input voltage is 36 V. The maximum permissible operating current is 2 A. Never exceed these limits. www.joy-it.net Pascalstr.
PAGE 2
. COMMISSIONING WITH THE RASPBERRY PI Vin - + Wiring: + Vout Raspberry Pi Mosfet GND (Pin 6) GND (Pin1) 3v3 (Pin 1) VCC (Pin2) NC NC (Pin3) BCM23 (Pin 16) Signal (Pin4) Code example: If the signal pin is set to high, the output is activated. In the following code example, the output is activated every 15 seconds for 10 seconds. from time import sleep import RPi.GPIO as GPIO GPIO.setmode(GPIO.BOARD) Signal_Pin = 16 GPIO.setup(Signal_Pin, GPIO.OUT) try: while True: GPIO.
PAGE 3
. COMMISSIONING WITH THE ARDUINO Wiring: Vin - + + Vout Arduino Mosfet GND GND (Pin1) 5V VCC (Pin2) NC NC (Pin3) Digital Pin 2 Signal (Pin4) Code example: If the signal pin is set to high, the output is activated. In the following code example, the output is activated every 15 seconds for 10 seconds. Before uploading, make sure that you have set the correct board and port in your Arduino IDE. void setup() { Serial.begin(9600); pinMode(2, OUTPUT); } void loop() { digitalWrite(2, HIGH); Serial.
PAGE 4
. ADDITIONAL INFORMATION PR Our information and take-back obligations according to the Electrical and Electronic Equipment Act (ElektroG) Symbol on electrical and electronic equipment: This crossed-out dustbin means that electrical and electronic appliances do not belong in the household waste. You must return the old appliances to a collection point. Before handing over waste batteries and accumulators that are not enclosed by waste equipment must be separated from it.