3 7“ Touch-Display Assembly Instruction Ausgabe 28.07.
3 7“ Touch-Display Assembling the Case Dear customer, thank you for purchasing our product. Please find our assembly instructions below: Assembling the case Warning: Before assembling the case, you need to remove the protective foil from all parts. At first, you need the front-part. Now the six white arcrylic screws need to be placed through the holes. The six spacers needs to be layed on the screws. Ausgabe 28.07.
7“ Touch-Display Assembling the case Stick the display on the mounting. Watch out that the cables of the display are on the same side as the indentation of the case. Now place another six spacers on the screws. You can now mount the backplate of the case. After that, you can screw the nuts on the case. Ausgabe 28.07.
3 7“ Touch-Display Assembling the base Assembling the base Take a white acrylic plate and a matching screw. These are, as seen on the picture, stuck inside a side panel. Screw a nut into the screw. Repeat this process until the base is fully assembled. Ausgabe 28.07.
3 7“ Touch-Display Mounting a single-board computer Banana Pi: Banana Pi M1 Banana Pi M2 Banana Pi M2 Ultra Banana Pi M2 Berry Banana Pi M3 Banana Pi M64 Raspberry Pi: Raspberry Pi A Raspberry Pi A+ Raspberry Pi B Raspberry Pi B + Raspberry Pi 2B Raspberry Pi 3B Other SBC: BeagleBone Black You can mount a lot of different single-board computers on the back of the case. Ausgabe 28.07.
