3 3 5 Inch HDMI LCD Ausgabe 22.02.
3 5 Inch HDMI LCD Index 1. Introduction 2. Working with a Raspberry Pi 2.1 Using our image 2.2 Using our driver 3. Support Ausgabe 22.02.
5 Inch HDMI LCD Dear customer, thank you for purchasing our product. Please find our instructions below. 1. Introduction 5 Inch resistive LCD-Touchscreen with LCD and HDMI interface. This display supports multiple systems. Please make sure you set the backlight switch to ON first. You can connect the display to the PC afterwards. You have to connect both, the USB-connection and the HDMI-connection. Ausgabe 22.02.
3 5 Inch HDMI LCD 2. Working with a Raspberry Pi While working with a Raspberry Pi, we recommend to set the display resolution by yourself. Otherwise the display might not work properly. You can either install our prepared image or you can install our display driver. The choice is up to you. If you choose to use our preinstalled system, please continue with the next step. If you want to install the display driver on your own, please skip the next step and continue with chapter 3.2. 2.
3 5 Inch HDMI LCD 2.2 Using our driver Please download our driver here and copy it to your Raspberry Pi. In the terminal of your Raspberry Pi, navigate to the config.txt file which is located in the bootdirectory of your SD-Card. Open the file with the following command: sudo nano config.txt In the now opened file, please append the following lines at the bottom. You can save the file with Ctrl+O and leave with Ctrl+X afterwards.
3 5 Inch HDMI LCD 3. Support If there are any further questions or problems, we can help you by mail, phone or by our ticket-supportsystem. E-Mail: service@joy-it.net Ticket-System: http://support.joy-it.net Telefon: +49 (0)2845 98469 – 66 (11- 18 Uhr) For further informations, please visit our homepage: www.joy-it.net Ausgabe 22.02.
