Instructions

ManualsBrandsJoy-it ManualsAutomationOperator interface panel

www.joy-it.net

Pascalstr. 8 47506 Neukirchen-Vluyn

2 BUTTON MODULE

SBC-Button2

1. GENERAL INFORMATION

Dear customer,

thank you very much for choosing our product.

In following, we will introduce you to what to observe while starting up

and using this product.

Should you encounter any unexpected problems during use, please do

not hesitate to contact us.

Connected as standard, the module is operated in high-active mode.

This means that a high signal is applied to the signal pin when the button

is pressed.

Due to the resistors integrated on the board, the signal is pulled to 0 V if

no button is pressed.

However, the module can also be operated low-active.

To do this, you only have to swap the VCC and GND connections.

This way a high signal is present when the button is not pressed and a

low signal when the button is pressed.

Summary of content (4 pages)

PAGE 1
2 BUTTON MODULE SBC-Button2 1. GENERAL INFORMATION Dear customer, thank you very much for choosing our product. In following, we will introduce you to what to observe while starting up and using this product. Should you encounter any unexpected problems during use, please do not hesitate to contact us. Connected as standard, the module is operated in high-active mode. This means that a high signal is applied to the signal pin when the button is pressed.
PAGE 2
. APPLICATION WITH THE RASPBERRY PI Wiring: Raspberry Pi Button Pin 11 (BCM 17) S1 Pin 13 (BCM 27) S2 5V VCC GND GND The following example program displays the status of the two buttons every 2 seconds. from time import sleep import RPi.GPIO as GPIO #Initialisation GPIO.setwarnings(False) GPIO.setmode(GPIO.BCM) button1 = 17 button2 = 27 GPIO.setup(button1, GPIO.IN) GPIO.setup(button2, GPIO.IN) # Button Query while True: if GPIO.input(button1) == GPIO.
PAGE 3
. APPLICATION WITH THE ARDUINO Wiring: Arduino Button Pin 11 S1 Pin 10 S2 5V VCC GND GND The following example program displays the status of the two buttons every 2 seconds. //Initialisation int Button1 = 10; int Button2 = 11; void setup(){ Serial.begin(9600); pinMode(Button1,INPUT); pinMode(Button2,INPUT); } //Button-Query void loop(){ if (digitalRead(Button1) == HIGH){ Serial.println("Button 1 pressed"); } else{ Serial.
PAGE 4
. ADDITIONAL INFORMATION Our information and take-back obligations according to the Electrical and Electronic Equipment Act (ElektroG) Symbol on electrical and electronic equipment: This crossed-out dustbin means that electrical and electronic appliances do not belong in the household waste. You must return the old appliances to a collection point. Before handing over waste batteries and accumulators that are not enclosed by waste equipment must be separated from it.