User manual

NodeMCU ESP32
Published: 26.09.2018 Copyright by Joy-IT 4
If you have not yet installed the Arduino IDE on your computer, download and install it rst.
Now open the Arduino IDE and change the board seng to "ESP32 Dev Module":
Download and install the updated CP210x USB-UART driver for your operang system.
The next step is to download the ocial ESP32 library.
Unpack the contents of the archive into the "hardware" folder of your Arduino folder ("C:\Users\[your
username]\Documents\Arduino\hardware").
Now restart your Arduino IDE. The module installaon is now complete.
3. MODULE INSTALLATION
Aenon! Aer the inial installaon, the baud rate may have changed to "921600". This may
cause problems. In this case, select the baud rate "115200" to avoid any problems.