Datasheet

6
7
b)Touch “ ” or “ ” to select the desired user No. and then touch “SET” to confirm to enter setting mode.
c)Touch “
” or “ ” to select gender or athlete mode and then touch “SET” to confirm.
d)Touch “
” or “ ” to set up the value of stature and then touch “SET” to confirm.
e)Touch “
” or “ ” to set up the value of age and touch “SET” to confirm. The data would be saved successfully, and then you may start measuring after
is shown on the LCD according to the measuring procedure below.
Note: If there is not any operation in setting mode, the scale will turn back to weighing mode after about 20s.
III.Measuring(select user manually)
a)Please put the scale on flat hard ground.
b)Touch “SET” to switch on and use “
” or “ ” to select your No..
c)Please wait until the LCD display “0.0”.
d)Stand on the platform with bare feet.
e)Stand still and the weight data will be locked automatically when stable.
f)The measuring will start automatically with the “o” signal moving from left to right.
g)After finishing measuring, the results will be shown in cycles for three times and then the scale turn off automatically.
IV.Measuring(user identification automatically)
a)Please stand on the flatform directly with bare feet to switch on.
b)Stand still and the weight data will be locked automatically when stable
c)The measuring will start automatically with the “o” signal moving from left to right.
d) If there is only one user whose last weight data is close to the current one, it will be selected automatically. The results will be shown in cycles for three times
and then the scale turn off.
e) If there are more than one users whose last weight datas are close to the current one, they would be shown on the LCD in cycles after calculation. For
example
f)Please use “ ” or “ ” to select the user. Touch “ ” to select “P1” and “ ” for “P2” .
Note: If there is not any selecting operation, the scale will turn off after about 40s.
g) After finishing selection, the results will be shown in cycles for three times and then the scale will turn off.
Note: Before using automatic user identification measuring method, please select your No. to measure once at least, or failed identification.
Indication message
a)Low battery indication. When “Lo” is shown, the scale will turn off after a few seconds and please change the batteries.