User's Manual

7
STATEMENT ON REGULATION
This product is designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generate, uses and
can radiate radio frequency energy and if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
z Reorient or relocate the receiving antenna.
z Increase the separation between the equipment and
receiver.
z Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
z Consult the dealer or an experienced radio/TV technician
for help.
Operation with non-approved equipment or unshielded cables is likely to
result in interference to radio or TV reception. The user is cautioned that
changes and modifications made to the equipment without the approval of
manufacturer could void the user’s authority to operate this equipment.
8
INSTALLATION
INSTALLING BATTERIES (EXCEPT JY-229TC)
Camera:
1. Remove the battery cover at the bottom or back of the unit.
2. Insert AA size batteries according to marking in the battery
compartment.
3. Align the battery cover tabs with the camera tab holes and replace the
cover.
Monitor:
1. Remove the battery cover at the back of the unit.
2. Insert AA size batteries according to the marking of the battery
compartment.
3. Align the battery cover tabs with the monitor tab holes and replace the
cover.
PLEASE NOTE:
1. Do not mix old and new batteries.
2. Do not mix alkaline, standard or rechargeable batteries
3. Remove the batteries during long period of non-use.
4. (European Version only) Due to specially designed circuitry for safety.
Only specially designed rechargeable battery can be recharged. Some of
the package may have this special battery included. Please contact your
dealer if you have any queries.
INSTALLING AC/DC ADAPTOR:
1. Install the plug of AC adaptor to the DC jack of the unit.
2. Plug the AC adaptor into a standard wall AC power outlet.
3. Switch on the unit with the power ON/OFF switch.
4. The power indicator will be illuminated.
Warning: Improper use of adaptor may cause malfunction of the units.
Please consult your dealer for any queries.
Please note that the service life of batteries is limited. Therefore, when
monitoring over long periods and, in particular, overnight, it’s recommended
to use AC adaptors for both camera and monitor unit.